03-05 4Runner Front Bumper Rear View03-05 4Runner Front Bumper Full Hoops Rear View03-05 4Runner Front Bumper Full Hoops Front View03-05 4Runner Front Bumper Center Hoop Rear View03-05 4Runner Front Bumper Center Hoop Front View4runner_03-05_frontbumper.24runner_03-05_frontbumper.1
2003-2005 4Runner / All Configurations

2003-2005 4Runner Steel Front Plate Bumper


Add to wishlist
Also Available in Aluminium
Product Details

2003-2005 Toyota 4Runner Steel Front Plate Bumper with blinker cutouts (& blinker lights), fog cutouts, 20″ LED bar cutout & LED cover & license plate holes

This Pelfreybilt Front Bumper comes standard with winch mounting provisions

Suggested lighting:
Baja Designs S8-20″ Driving Combo LED Light Bar (70-2003)
Baja Designs Squadron-R Sport-Pair, Wide Cornering Fog Lights (58-7805)

All bumpers come standard with:

_1/4″ Steel Formed Reinforcement Brackets
_ 3/4″ D-ring mounts.
_ 20″ Single Row LED light bar and fog light cutouts.
_ 20″ light bar cutout filler plate included with purchase

2003-2005 4Runner Steel Front Plate Bumper

Current Lead time: 3-5 weeks BARE WITH NO HOOPS, 4-6 weeks POWDER COATED, 6-8 weeks WITH HOOPS, BARE or POWDER COATED (Lead times are approximate)

Technical Specs

2003-2005 4Runner / All Configurations
Full Hoops 125Ibs, Center Hoop 115lbs, No Hoops 105lbs
2003-2005 4Runner Steel Front Plate Bumper INSTALLATION

Start by removing the factory bumper. First the grille should be removed by pulling the plastic clips at the top of the grille and removing the two screws. The grill should pull upward from the truck, there are two small clips at the bottom of the grille. The bumper has several bolts and clips at the bottom and in the wheel wells, be sure all clips and bolts are removed and the bumper will pop out toward the front. There are black “hubs” on either side of the fenders that the bumper clicks into, they should also be removed. Next step is to remove the factory aluminum crash bumper, it is held on by 6 nuts, 3 on each side. Save the nuts, they will be reused. The crash bumper is often a press fit onto the studs and will require using rubber mallet or dead blow to push the bumper off. Remove the factory
tow hook that is on the passenger side of the truck, bolted to bottom of cross-member. The tow hook that is permanently welded on the driver’s side will
Factory skid plates may need tabs trimmed for installation.

Full Installation Instructions


There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Let’s be Social