2005-2015 Tacoma Hi-Clearance Rear, without LED, for gate2005-2015 Tacoma Hi-Clearance Rear, without LED2005-2015 Tacoma Hi-Clearance Rear, with LED, for gate2005-2015 Tacoma Hi-Clearance Rear, with LED, for gate (1)Swing Out Gate-Tire CarrierSwing Out Gate-Tire Carrier (1)livelytc2hIMG_2905Pelfry 5_zpshylcskmv
2005-2011 Tacoma / All Configurations

2005-2015 Tacoma Rear Hi-Clearance Bumper with Gate

$1,599.00$2,225.00

Clear
Add to wishlist
Also Available in Steel
Product Details

2005-2015 Toyota Tacoma Rear Hi-Clearance Bumper with Hidden Hitch with Flip Down License Plate Holder, Gate with Rotopax Mount for Gate.

Additional Gate products available include: Hi-Lift mount, Table Mount and Dual NATO can carrier

This bumper requires cutting the bedsides for additional protection. You will use the factory license plate lights and trailer wiring harness. The hidden hitch feature adds a substantial amount of additional clearance. Fender supports and trim for the cut area are included with bumper. While not rated, this bumper was designed & tested for factory recommended tow capacity.

Recommended Lights:
S2 Pro, LED Wide Cornering, Flush Mount Pair | Baja Designs  (47-7807)

Bumper weighs 140 pounds. Gate adds 50 pounds

All bumpers come bare, with 3/4″ D-ring mounts & hidden hitch
Includes reverse light cutouts w/ filler plates. Cutouts designed for Baja Designs S2 Flush Mounts (Sold separately). Includes flip-up license plate mount.

Frame mounting points are 1/2″ steel. Main structure is 3/16″.

2005-2015 Tacoma Rear Hi-Clearance Bumper WITH GATE

Current Lead time: 14-16 weeks (Lead times are approximate)

Installation Instructions

 

Technical Specs

material
Steel
truck-options
2005-2011 Tacoma / All Configurations
2005-2015 Tacoma Rear Hi-Clearance Bumper WITH GATE INSTALLATION
Start by removing the factory bumper. Strip off the hitch harness and all the lighting. Remove the 5
bolts that mount bumper and hitch combo to the frame. These bolts will be reused. The bumper has a
locating pin that needs to be dislodged by pulling up and out on bumper. Next step is to remove the fender flares. Remove the screws around the inside perimeter and unclip the plastic clips. Use caution, the clips are fragile; you will likely break a few of them. They can be squeezed from inside the fender to remove. You have to pull back the fender liner to access. Remove the factory fender support bracket at this time, unbolt it from the bed and save hardware, it will be reused.

WHAT OTHER PEOPLE ARE SAYING

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Let’s be Social