2006-2009 4Runner / All Configurations
$950.00 – $1,365.00
2006-2009 Toyota 4Runner Steel Front Plate Bumper with fog Light cutouts, 20″ LED bar cutout & LED bar cover & license plate holes
This Pelfreybilt Front Bumper comes standard with winch mounting provisions
All bumpers come standard with:
_1/4″ Steel Formed Reinforcement Brackets
_ 3/4″ D-ring mounts.
_ 20″ Single Row LED light bar and fog light cutouts.
_ 20″ light bar cutout filler plate included with purchase.
2006-2009 4Runner Steel Front Plate Bumper
- 2006-2009 4Runner / All Configurations
- Full Hoops 125Ibs, Center Hoop 115lbs, No Hoops 105lbs
2006-2009 4Runner Steel Front Plate Bumper INSTALLATION
Start by removing the factory bumper. The bumper has several bolts and clips at the bottom and in the wheel wells, be sure all clips and bolts are removed and the bumper will pop out toward the front. The black plastic “click in” pieces that hold the factory plastic bumper should be removed. Next step is to remove the factory aluminum crash bumper, it is held on by 8 bolts, 3 on each side. Save the bolts, they will be reused.
Before mounting all of your accessories onto the bumper it is a good idea to do a test fit. With two people minimum, carefully lift the bumper up onto the studs, use caution not to hit the fenders with the bumper. 3 people are ideal, 2 to lift and one to start the bolts. Check alignment, the bumper can be raised and lowered to fit each different truck. The tilt of the bumper can be manipulated if needed by placing washers on the studs, either top or bottom depending on needs. It is a good idea to leave appx ½” gap from fenders to allow for body flex. The L – shape reinforcement brackets bolt up using the supplied 12mm bolts. These mount to the sides of the lower cross – member. The supplied elongated washers are to be used on the face of the bumper, outside 3 bolts, each side.