4runner.lawndart.32005-2016 Tacoma Bolt On Rock Siders with Top Plates
2010-2016 4Runner / SR5, Pro Edition

2014-2017 4Runner Bolt on Sliders


Add to wishlist
Product Details

2014-2017 Toyota 4Runner Bolt on Sliders

Direct bolt on, no drilling required

Hybrid Tubing configuration, 2.0″ x .120″ wall Square HREW, Main tube and Mounting legs.  Outer tube is 1.75″ x .120″ wall Round DOM. Mounting Plates are 1/4″ Steel

Weighs approximately 100# per set

Top Plates and Powder Coating are extra available options

2014-2017 4Runner Bolt on Sliders

Current Lead time: 12-14 weeks (Lead times are approximate)

Technical Specs

2010-2016 4Runner / SR5, Pro Edition
2014-2017 4Runner Bolt on Slider INSTALLATION

The SR5 and TRD Pro models will bolt directly up using supplied hardware. Trail Edition vehicles with the KDSS have a different driver’s side slider that has different mounting plates to work around the KDSS. You will need to remove the lower supply line skid plate and the supply line mounts from the frame. The slider mounting plate will slide under the supply line mounts. You may need to lightly pry the lines out to slide the slider under the lines. The supplied hardware should be used in place of the factory hardware where the supply lines mount; the supplied hardware is higher strength. Once the slider is in place you can replace the factory supply line skid. The sliders should be tightened down to approximately 40ft/lbs and rechecked frequently. For heavy use it is a good idea to make a few small welds at the base of the sliders to prevent any slight deflection and potential loosening of the hardware. This is not a requirement but a good measure for people that will be putting their vehicles through heavy abuse.

Full installation instructions



There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Let’s be Social