IMG_8871IMG_8922Joey’s 2016 Toyota TacomaIMG_8753
2016+ Tacoma / All Configurations

2016-2017 Tacoma Rear Hi-Clearance Bumper

$1,025.00$1,225.00

Clear
Add to wishlist
Product Details

2016-2017 Toyota Tacoma Rear Hi-Clearance Bumper Hidden Hitch, License plate light cutouts, with Flip Down License Plate Holder

All bumpers come standard with parking sensor cutouts with optional filler plates provided.

This bumper requires cutting the bedsides for additional protection. You will use the factory license plate lights and trailer wiring harness. The hidden hitch feature adds a substantial amount of additional clearance. Fender supports and trim for the cut area are included with bumper.

Recommended Lights:
S2 Pro, LED Wide Cornering, Flush Mount Pair | Baja Designs  (47-7807)

Hidden Hitch behind license plate-same as 2nd Gen Design
¾” D-Ring Mounts
Frame Mounting points are 1/2” steel
Main Structure 3/16” steel
Includes reverse light cutouts w/ filler plates. Cutouts designed for Baja Designs S2 Flush Mounts (Sold separately)
Includes flip-up license plate mount
Custom license plate light holes for factory lights

Just as with our 2nd Gen Tacoma Rear Bumpers, the Factory Hitch does not work with this bumper.
While not officially rated, our rear bumpers are designed & tested for factory recommended tow capacity.

2016-2017 Tacoma Rear Hi-Clearance Bumper

Current Lead time: Approximately 8 weeks bare, 8-10 weeks with powder coating | Installation Instructions

*Disclaimer: Blind spot detection monitors will not work with this bumper, the signal will not transmit through steel.

Technical Specs

truck-options
2016+ Tacoma / All Configurations
2016-2017 Tacoma Rear Hi-Clearance Bumper INSTALLATION

Start by removing the factory bumper. Strip off the hitch harness and all the lighting. Remove the 5 bolts that mount bumper and hitch combo to the frame. These bolts will be reused. The bumper has a locating pin that needs to be dislodged by pulling up and out on bumper. Next step is to remove the fender flares. Remove the screws around the inside perimeter and unclip the plastic clips. Use caution, the clips are fragile; you will likely break a few of them. They can be squeezed from inside the fender to remove. You have to pull back the fender liner to access. Remove the factory fender support bracket at this time, unbolt it from the bed and save hardware, it will be reused.

Full Installation Instructions

WHAT OTHER PEOPLE ARE SAYING

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Let’s be Social